• Waterproofing of water-tanks and wastewater treatment tanks
• Waterproofing of swimming pools
• Waterproofing of basements, garages and flower boxes
• Waterproofing of outer walls of new buildings
• Repair of frost damaged surfaces
• Protection from deicing salts on bridges, dams and retaining walls

• It is easy in application
• It is easy in mixing
• High abrasion resistance
• No cracking when properly applied
• It does not affect the reinforcing steel or other building materials
• Suitable for application in potable water tanks in accordance with W-347 requirements

Clean well and remove any loose pieces, dust, formwork’s oil and grease from surface. All leaks shall be properly sealed in advance with DOMORAPID (see instructions). Corners should be rounded with DOMOREP or cement mortar with DOMOPLAST (see instruction manual). Remove plaster finishes where appropriate up to 50 cm above water level and carefully seal joints using DOMOPLAST. The substrates should be wetted without standing water.

Mixing: Add 25 kg (bag) DOMOTOP DS into a container of 5-6 kg of water, under continuous stirring. The use of a 600 – 800 rpm mixer is recommended. Mix until full homogenization (3 to 4 minutes).

Application: Wet substrate when absorbing, apply first layer. After sufficient hardening (2 to 6 hours according to temperature) apply second layer. Application can be made using a wide brush. Two layers are usually needed. Finish with sponge. Always apply on wet substrate. Minimum temperature 5°C. Cleaning with water before the hardening of the material.

DOMOTOP DS is compatible with the range of admixtures offered by our company.

Packaging: Bags of 25 kg, 5 kg.

Shelf life: At least 6 months at a dry spot.

Consumption: From 2 to 5 kg/m² according to need. Usually 3 kg are enough.